Following a brief period with no stock, we’ve restocked the original 32mm x 22mm x 4mm diametric ring magnet at mjbots.com. Additionally, there are now 4 new sizes to choose from:
This should hopefully let you use low cost (albeit low accuracy), off axis diametric ring magnets in even more applications. Good luck!
To go with the new MA600 breakout board, mjbots.com is now stocking diametrically magnetized ring magnets:
For now, the only size is 32mm x 22mm x 4mm, but there may be more in the future. These are magnetized through the radius, not axially, so they are suited for use with off axis magnetic encoders. Check it out!
I’ve been exploring how to add low cost off-axis encoder support into moteus, see part 1, and part 2. In this part, I’ll look at a magnet and how to get it installed on the test motor.
To start, this method of operation will require a diametrically magnetized ring magnet, i.e. one where the axis of magnetization is through the diameter rather than through its depth.
That is not a terribly common magnet configuration, but there are some vendors. For this experiment, I used a 32mm OD ring magnet from RLS that is intended for use with their Orbis line of encoders, part number BM220C320A1ABA00. The motor I am using for this test is a T-Motor GL80, which has a hollow shaft. To mate the magnet to the motor, I 3d printed a fixture (purple) which slipped over the bearing surfaces of the GL80 (pink), and captured the magnet (red).
